Calibration – Check

Go to print – big goopy mess

Change nozzle – Check

Calibration – Check

repeat

After a lot of frustration I saw the wires for my part cooling fan pop out of the connector and I immediately knew what the problem was. Ugh. I had spent so much time diagnosing the wrong issue. The wires were in enough that they looked like they were secure, but out enough that they intermittently got disconnected. So, when I would print I would sometimes end up with heat creep or a big goopy mess of filament.

Bought 500 JST connectors on Amazon for $8.99 and my problem is solved.

Lessons learned (or relearned):

• the root cause isn’t always immediately obvious

• check everything

• if you’ve replaced the nozzle 3 times and you still have the same problem, the problem likely isn’t the nozzle