Have you ever wondered why your 3D prints sometimes don’t stick to the bed or have warped edges? One possible reason is that your bed is not properly warmed up before you start printing. Sometimes, you need to let your bed “soak” for a little while before you begin printing.
The bed of a 3D printer is usually made of metal, glass, or plastic, and it is heated by a heating element underneath. The purpose of heating the bed is to provide a stable and smooth surface for the first layer of the print to adhere to, and to prevent thermal contraction of the material as it cools down. However, heating the bed also causes it to expand and contract slightly, which can affect its shape and flatness.
Depending on the material and thickness of the bed, it can take some time for the bed to reach a uniform temperature and stabilize its shape. If you start printing too soon, the bed may still be flexing and adjusting its shape as it warms up, which can cause uneven adhesion, gaps, or curling of the first layer. This can ruin the quality of your print or even make it fail completely.
To avoid this problem, you should always preheat your bed before you start printing. You can do this by setting the bed temperature in your slicer software or on your printer’s LCD screen, and waiting for a few minutes until the temperature is reached and stable. I’ve found it very helpful to set my hotend and bed temperatures, and then go get a cup of coffee. I’ve found that the time it takes me to do this is good enough for the bed to be thoroughly heated, not just heated where the sensor itself is. If you want a more technical answer you can use a thermometer or an infrared camera to check the temperature distribution on the bed surface and make sure it is consistent.
By preheating your bed properly, you can ensure that your first layer sticks well and that your print has a solid foundation. This will improve the quality and reliability of your 3D prints and save you time and frustration. So next time you are ready to print something, don’t forget to get a cup of coffee!