3D printing is an amazing technology that allows you to create anything you can imagine. However, it is not always easy to get the perfect print. Sometimes, you may encounter problems such as stringing, warping, clogging, or under-extrusion. These problems can ruin your print quality and waste your time and filament.

Today, I would like to step out of the technical aspects of 3d printing and talk a little bit about more of a process. I want to demonstrate the process that I go through in taking a symptom, such as “my 3d print has a lot of stringing” or “my 3d print is coming off of the bed” and turn that into actionable troubleshooting steps. Granted, some of this is knowledge that comes with experience, and there just isn’t a way around that part of it.

Step 1: Identify the symptom

The first step is to identify the symptom that you are experiencing. For example, stringing is when thin strands of filament are left between different parts of your print. Warping is when the edges of your print curl up and detach from the bed. Clogging is when the nozzle gets blocked by melted filament and prevents extrusion. Under-extrusion is when the nozzle does not extrude enough filament and leaves gaps or holes in your print.

Step 2: Find the possible causes

The next step is to find the possible causes of your symptom. For example, stringing can be caused by high printing temperature, low retraction speed, or too much moisture in the filament. Warping can be caused by low bed temperature, poor bed adhesion, or large temperature differences between layers. Clogging can be caused by dirty nozzle, incompatible filament materials, or incorrect nozzle size. Under-extrusion can be caused by low printing temperature, low flow rate, or partial clogging. This step is done either by trial and error or research. I prefer research.

Step 3: Apply the solutions

The final step is to apply the solutions that can fix your problem. A solution is a method or action that can eliminate or reduce the cause of your symptom and improve your print quality. For example, to reduce stringing, you can lower your printing temperature, increase your retraction speed, or dry your filament before printing. To prevent warping, you can increase your bed temperature, use a raft or brim, or enclose your printer to maintain a stable temperature. To clear clogging, you can clean your nozzle with a needle or a wire brush, use compatible filament materials, or change your nozzle size. To avoid under-extrusion, you can increase your printing temperature, increase your flow rate, or check for partial clogging.