Have you ever experienced a thermal runaway error on your 3D printer? If you have, you know how frustrating and scary it can be. Thermal runaway is a condition where the temperature of the hotend or the heated bed rises uncontrollably, potentially causing damage to the printer or even starting a fire. I will explain what causes thermal runaway, how to prevent it, and what to do if it happens.
The main cause of thermal runaway is a malfunction in the temperature sensor or the heater. The temperature sensor is a device that measures the temperature of the hotend or the heated bed and sends a signal to the controller board. The controller board then adjusts the power to the heater to maintain the desired temperature. If the temperature sensor fails or becomes loose, it may send a wrong signal to the controller board, causing it to overheat or underheat the heater. Similarly, if the heater fails or becomes loose, it may draw too much or too little power, causing it to overheat or underheat.
To prevent thermal runaway, you should always check your printer for any signs of damage or wear before each print. Make sure that the temperature sensor and the heater are securely attached and that the wires are not frayed or broken. You should also enable thermal runaway protection in your firmware if your printer supports it. Thermal runaway protection is a feature that monitors the temperature of the hotend and the heated bed and shuts off the power if it detects an abnormal change. It’s not always enabled by default, so make sure it is turned on before you start printing.
If you encounter a thermal runaway error during a print, you should immediately turn off your printer and unplug it from the power source. Do not touch any part of the printer until it cools down completely. Then, inspect your printer for any damage or loose connections and fix them if possible. You may need to replace the temperature sensor or the heater if they are faulty. You should also update your firmware to the latest version and enable thermal runaway protection if you haven’t done so already.